Hi Tom and Scott, I notice that the QRT 5 International will scan through all frequencies and all bandwidths when not receiving a cell station when using /interface wireless monitor 0 You can do this in the house and it might give you an idea what frequencies and bandwidths are being scanned by the modem. 73 David WA9ONY
On Aug 26, 2018, at 9:16 PM, Tom Hayward <tom@tomh.us> wrote:
On Sun, Aug 26, 2018 at 9:08 PM Scott J. Burrows <sburrows97211@comcast.net <mailto:sburrows97211@comcast.net>> wrote: However, the RBLHGG-5acD (Node-1) would not locate any sector modems. I verified it was the International version and updated to lastest software and firmware. But did notice the WiFi Interfaces reported multiple unsupported channels and the following:
-- in scan-list does not contain valid channels -- empty scanlist
Does anyone know what is causing this problem? If so, what is the fix.
Many of Mikrotik's 802.11ac modems do not support 5 and 10 MHz channels like we use for HamWAN. It could be that this model is not capable.
You could try testing it in AP mode to see if it gives you similar errors: /interface wireless set wlan1 mode=ap-bridge channel-width=5mhz print
Then to get it back into client mode: /interface wireless set wlan1 mode=station
Tom _______________________________________________ PSDR mailing list PSDR@hamwan.org http://mail.hamwan.net/mailman/listinfo/psdr