Bob, One out-of-the-blue question: Do you have both chains enabled on the radio? The factory default setting (for the RB912UAG-5HPnD at least) is to just enable chain 0.  Last time I checked, the configuration instructions on the HamWAN web site don't enable the second chain (chain 1).  Enabling the second chain can make a pretty substantial difference in net signal margin and stability. Assuming that you are using a MIMO radio, to check this run: /interface wireless monitor 0 once You should have these lines in the display: signal-strength: signal-strength-ch0: signal-strength-ch1: tx-signal-strength: tx-signal-strength-ch0: tx-signal-strength-ch1:  If you only have the following, then you are running in single-chain mode: signal-strength: signal-strength-ch0: tx-signal-strength: tx-signal-strength-ch0: To enable both chains: /interface wireless set 0 rx-chains=0,1 tx-chains=0,1 John KX7JM John C. Miller mailto:john@jmit.com (530)873-9005 ---- On Sat, 29 Feb 2020 05:51:14 -0800 Bob.k6mby <k6mby@olypen.com> wrote ---- Thanks Carl. Went in the wireless tab and set country and frequency mode then ran the regular item 21 config line and it went without error. Bob K6MBY Sequim, WA _______________________________________________ PSDR mailing list mailto:PSDR@hamwan.org http://mail.hamwan.net/mailman/listinfo/psdr